膜科学与技术

高温拉伸制备交联聚乙烯微孔膜的探索研究

作者：任冬雪，孙小杰

单位：北京低碳清洁能源研究院，北京 102209

关键词：聚乙烯；微孔膜；交联

出版年,卷(期):页码： 2021,41(1):50-56

摘要：

采用热拉伸-高温退火-冷拉的拉伸工艺制备了交联聚乙烯微孔膜，考察了交联聚乙烯的交联度、拉伸温度、退火温度和冷拉等工艺条件对交联聚乙烯微孔膜成孔性能的影响，并对成孔过程和机理进行了探讨。交联聚乙烯的交联度显著影响成孔性能，随着交联度的增加，成孔性增加。拉伸温度在90℃-120℃时，膜片基本由纤维状晶构成。拉伸温度升至130℃，并在此温度进行高温退火处理，膜片开始出现细缝状微孔。施加冷拉可以调控细缝状微孔形态演变，进一步被拉伸成圆形或椭圆洞状微孔。本文所用拉伸工艺为制备高性能聚乙烯微孔膜提供了一种新的思路，有助于开发自主知识产权的聚乙烯微孔膜技术，突破锂离子电池隔膜等高端聚乙烯微孔膜的国外技术垄断。

Cross-linked polyethylene microporous membranes were prepared by a new stretching process including hot stretching, high temperature annealing and cold drawing. The process conditions such as cross-linking degree, stretching temperature, annealing temperature and cold drawing of cross-linked polyethylene were investigated. The effect of the pore-forming performance of polyethylene microporous membrane, the pore-forming process and mechanism were discussed. The degree of cross-linking of cross-linked polyethylene significantly affects the pore-forming performance. As the degree of cross-linking increases, the porosity increases. When the stretching temperature is between 90 ° C and 120 ° C, the membrane is basically composed of fibrous crystals. The stretching temperature was raised to 130 ° C and high-temperature annealing treatment was performed at this temperature, the film began to appear fine slit-shaped micropores. The application of cold-drawing can regulate the morphological evolution of the slit-shaped micropores, which are further stretched into circular or elliptical micropores. The new stretching process provides a new idea for the preparation of high-performance polyethylene microporous membranes.

任冬雪，女，硕士，北京低碳清洁能源研究所，主管工程师，主要研究方向为先进材料功能膜的制备和应用研究，email: dongxue.ren@chnenergy.com.cn

参考文献：

[1] ARORA P, ZHANG Z M. Battery Separators[J]. Chemical Reviews, 2004, 104(10):4419-4462
[2] 刘葭, 丁治天, 刘正英，等. 辊速辊温对高密度聚乙烯拉伸微孔膜及其片晶结构的影响 [J].高分子学报，2011,(11):1278-1283
[3] Lee S Y， Park S Y， Song H S．Effects of melt-extension and annealing on row-nucleated lamellar crystalline structure of HDPE films[J]. J Appl Polym Sci， 2007， 103( 5) :3326- 3333
[4] Lee S Y， Park S Y， Song H S．Lamellar crystalline structure of hard elastic HDPE films and its influence on microporous membrane formation[J]. Polymer， 2006， 47( 10) :3540- 3547
[5] 顾旭, 郑泓, 周持兴, 等. 热致相分离法UHMWPE/HDPE微孔膜的制备及性能[J] . 高分子材料科学与工程, 2012, 28(12)：138-141
[6] 朱灵玲，胡祖明，于俊荣，等. 高分子量聚乙烯微孔膜的研究进展[J]. 胶体与聚合物，2012, 30(2):93-96
[7] LEE H, YANILMAZ M, TOPRAKCI O, et al. A review of recent developments in membrane separators for rechargeable lithium ion batteries[J]. Energy Environ. Sci., 2014, 7(12):3857-3886
[8] 丁治天, 刘正英, 刘葭, 等. 高分子量级分含量对熔体挤出拉伸法制备聚丙烯微孔膜的影响[J]. 高分子学报，2012, (4): 462-468
[9]Farhad S， Abdellah A， Pierre J C．Analysis of microporous membranes obtained from polypropylene films by stretching [J]. J Membr Sci., 2007， 292 ( 12) :62 ～71
[10] 王正洲, 瞿保钧, 范维澄,等. 聚乙烯的交联技术研究进展[J]. 高分子材料科学与工程, 2001, 17(1):7-10
[11] 刘新民. 交联聚乙烯的应用及技术进展[J]. 合成树脂及塑料, 2003, 20(5) : 52-55
[12] 任冬雪，孙小杰，梁文斌. 高耐热交联聚乙烯微孔膜的制备及性能研究 [J]. 膜科学与技术，2019，39（6）:80-86
[13] 孙小杰，陈学连，梁文斌. 高密度聚乙烯的交联过程和结晶行为研究[J]. 塑料工业，2016, 44（11）:108-111
[14] Wang, R Ren D X, Sun X J, etal. Structure Variation and Puncture Resistance of Stretched Crosslinked Polyethylene Film: Effects of Stretching Temperature[J]. J. Appl. Polym. Sci. 2019, 136(16), 47542
[15 ] 沈鹏,杨兴成, 朱梦冰,等. 流延工艺条件对聚乙烯流延基膜取向片晶结构和拉伸成孔性的影响[J]. 高分子材料科学与工程, 2015, 31(5):129-134
[16] Wang Z B, An M F, Xu H J, etal. Structural evolution from shish-kebab to fibrillar crystals during hot-stretching process of gel spinning ultra-high molecular weight polyethylene fibers obtained from low concentration solution[J]. Polymer, 2017, 120(11), 244
[17] 张国耀，徐力平，姜宁，等. 热拉伸的超高分子量聚乙烯的晶体结构和力学性能 [J]. 高分子学报，1995,(5): 577-585
[18] 赵勇, 杨德才. 聚乙烯串晶在单轴拉伸形变过程中的微结构变化和机理[J]. 高分子学报, 1994, (6): 647-652
[19] 杨哲. 热致感应型形状记忆高分子材料的研究[J]. 高分子材料科学与工程,1997,13(4)：19-23
[20] 李朝，王知学，常芳娥，等. 层压制备交联 LDPE 及其形状记忆性能的研究[J]. 塑料工业，2011，39(11):71-74
[21] Nezafat P, Jafari S H, Khonakdar H A, etal. Experimental analysis and mechanical modeling of effect of stress-relaxation on shape memory and recovery behavior of e-beam irradiated HDPE[J]. Radiat. Phys. Chem., 2020, 168 : 1-12
[22] 龙文保, 吴大呜, 刘颖,等. 化学交联聚乙烯热收缩管扩管工艺[J].塑料, 1996 , 25(2):42-46
[23] Khonakdar H A K , Morshedian J , Mehrabzadeh M , et al. Thermal and shrinkage behaviour of stretched peroxide-crosslinked high-density polyethylene[J]. Eur. Polym. J., 2003, 39(8):1729-1734.

服务与反馈：

【文章下载】【加入收藏】

《膜科学与技术》编辑部地址：北京市朝阳区北三环东路19号蓝星大厦邮政编码：100029 电话：010-64426130/64433466 传真：010-80485372邮箱：mkxyjs@163.com